R.W. Hale & Associates, Rebuilt Foundry Equipment, Ladles, Core Equipment

• Water blast cleaning of unit and any accessories.
• Disassemble and remove all items and controls to bare frame.
• Clean and inspect all components.
• Replace all items not serviceables
• Rebuild all serviceable items
• Regrind mounting surfaces flat.
• Sandblast main weldments and castings.
• Install new shafting.
• Reassemble machine using new bushings, bearings, and seals.
• Re-plumb the unit with new hose
• Re-plumb and repair the gas burner systems
• Rewire all machine mounted electrics
• Paint unit complete
• Run, test, and adjust machine.
• Load unit for shipment to your location.

All machines are supplied with a new control panel and PLC control. Panel includes:

• New NEMA enclosure
• Fused flanged disconnect
• Allen Bradley components throughout
• AB Micrologic PLC controller with EPROM memory chip and fused outputs
• Indicating fuses
• Internal transformer for 460 3ph to 110 vac control circuitry
• New 35mm Allen Bradley control buttons
• Allen Bradley DTAM access source for timing and fault warnings
• Ladder logic printout, hard wiring diagram, and the PLC program
• Unit wiring and testing
• Updated copy of the operations and part list manual

All re-manufacturing by R.W.Hale and Associates includes replacement of the control package with the latest equipment. Using a new NEMA enclosure, a new electrical package including PLC control is installed and programmed. The latest NEC specifications are implemented for both operator and maintenance personnel protection and safety. PLC outputs are fused and all machine wiring is pulled with new wire numbers for future ease of troubleshooting. Above all, there is documentation supplied including the PLC program and hardwiring schematics.

A new panel layout and logical control progression lends itself to increased operator productivity. LCD timers are utilized on all panels decreasing the physical panel size and allowing for more flexibility and control of the process variables. R.W.Hale and Associates is continually updating the panel package to incorporate the latest in customer input. At R.W.Hale and Associates we incorporate what has been working for you.

The reliability of today's electronics gives a remanufactured machine more reliability and enhances your bottom line. Purchase a used machine and you get someone else's problems. Put your unit through the re-manufacturing process and you have enhanced the quality of your original investment. Good as new at a fraction of the cost.